Manufacturer Reviews

For those that may be wondering, the existing floor where Tony is kneeling will be replaced with ceramic tile. I would suggest if you have a new floor in that area, cover to protect it when doing this work. Incidentally, considering ceramic tile will be installed, it is recommended any tile work be done before a hardwood flooring

project. Doing so will negate any potential damage that seems to come when work is performed in that order. In this case scheduling problems did not allow. Best to plan ahead.

The circular saw will miss approximately three inches from each side of the step when you make the cut. One trick that helps removing the cut piece at once would be making a cut in the center of the step. Using a pry bar, pull both pieces off. If you should happen to run into plywood steps we suggest using a jig saw to cut the remaining that the circular saw missed.

As long as there aren't any knots on the sides of the step, the pieces should pull off clean with a little chisel work needed; shown below right.

For steps that are mortised it's wise to cut to the side of each riser with a jig or hand saw or be extra careful when removing the pieces. Wiggle each piece until it beaks free, being careful not to damage the stair skirting itself. It is likely to be be glued and in some cases nailed or screwed from the underside.

Mortised Steps?

For mortised steps, you will have left behind, a gaping hole that needs to be addressed before continuing. Depending on the flooring thickness being used, plywood can be attached to the step riser. Once both plywood and flooring material is installed it should cover the open mortised joint. Another option would be to fill with some type of wood putty. One that will not shrink or crack and sands easily. It's up to you, but I found the plywood idea to be quicker and cleaner.

Did I Mention Squeaky Steps?

Sure did! It doesn't hurt to mention it again. The lady of the house will not be pleased if your cover up the steps then all of a sudden they start squeaking. Check the condition of the risers and steps before continuing. If they squeak, your new steps will do the same. Make sure they are flat. Other methods to correct squeaks include long decking screws. Or if you can access them from below; have a partner help from above. Use wood shims and wedge them into place between areas that may have loosen up over the years on the underside of the staircase.

Who Is This Guy?

A little note about our installer, Tony Garrison. Tony resides in Zephyrhills, Florida has been in the flooring business for over twenty years. Originally in the carpet, vinyl, and ceramic tile trade, Tony has been installing hardwood floors for ten years as of this site update, March 2008.

We consider his workmanship to be excellent with attention to detail, having worked with him on three jobs over the years. You'll find his personality entertaining and easy going. Those interested in talking to, or hiring Tony can use his Email or call 813-713-1535. He's willing to take on jobs in the Tampa, Lutz, Temple Terrace areas, east to Plant City, and Lakeland and is not limited to hardwood flooring. Tony also handles laminate floor installations.